calculadora de ingeniería
Voltage Coefficient (VCR) Error Calculator
Cómo leer el diagrama. The top resistor changes value as the voltage across it rises, so the ratio at 20 kV is not the ratio you measured on the bench. The curve is that drift and dR/R is the error the calculator returns.
A thick film resistor is not the same value at 20 kV as on a bench meter. VCR is quoted in ppm per volt; this turns it into the resistance change and the divider error it causes.
Ingresos
Resultados
- R1 change
- -
- Ratio at 0 V
- -
- Ratio at working V
- -
- Error de proporción
- -
- Output at working V
- -
La fórmula
ΔR/R = VCR × V / 1,000,000. Divider ratio = (R1 + R2) / R2; recalculate it with the shifted R1 to get the error.
Lo que la calculadora no incluye
- TCR. The resistor also drifts with temperature and the two effects add. A part with −1 ppm/V and 25 ppm/°C can drift more from a 40 °C rise than from full voltage.
- Non-linearity. VCR is not perfectly linear; the quoted figure is typical at rated voltage.
- Self-heating. Current through R1 raises its temperature, which shifts the value again.
Eligiendo las partes
Where the ratio matters, specify VCR explicitly: the gama de películas gruesas planas is quoted for precision divider use, tolerance from 0.2%. For matched pairs, send the ratio and the voltage.
Envíe los valores calculados y el arancel: Solicitar presupuesto técnico, respuesta en 6 horas.